Service And Repairs; Rotary Cutting Units - Toro Groundmaster Series Service Manual

Service and Repairs

Rotary Cutting Units

Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
Do not start the engine and engage the PTO switch when the PTO
shaft is disconnected from the cutting unit. If you start the engine
and the PTO shaft is allowed to rotate, serious personal injury and
machine damage could result.
If the PTO shaft is disconnected from the cutting unit, disconnect
the PTO electric clutch electrical connector.
Do not work on the cutting unit or lift arms with the engine running.
Always shut off the engine and remove the key from the key switch
before working on the cutting unit.
Refer to specific cutting unit Operator's Manual for the cutting unit removal and
installation procedures.
Tighten the cutting unit bumper pad mounting screws until the screw heads are
just below the surface of the pad; refer to
g315013
WARNING
CAUTION
Figure
Figure 131
Cutting Unit Bumper Pad (typical)
Page 8–3
131).
Cutting Units: Service and Repairs