Toro Groundmaster Series Service Manual page 165

Disassembling the Gear Pump (continued)
Inspecting the Gear Pump
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
g303052
1. Marker line
Use caution when clamping gear pump in a vise to avoid distorting
any pump components.
3. Secure the front cover of the pump in a vise with the drive shaft pointing down.
4. Loosen the four (4) cap screws that secure the pump section to the front
cover.
5. Remove the pump from the vise and remove the fasteners.
Note: Be careful to not drop parts or disengage gear mesh when separating
pump sections.
6. Support the pump assembly and gently tap the pump bodies with a soft face
hammer to loosen the pump section.
Mark the relative positions of the gear teeth and the thrust plates so
they can be reassembled in the same position. Do not touch the gear
surfaces as residue on hands may be corrosive to gear finish.
7. Remove the thrust plates and the seals. Before removing the gear set, apply
marking dye to the mating teeth to retain the "timing". Pump efficiency may
be affected if the teeth are not installed in the same position during assembly.
If internal parts are found to be worn or damaged, gear pump replacement
is necessary.
1. Remove any nicks and burrs from all parts with emery cloth.
Figure 56
IMPORTANT
IMPORTANT
Page 5–79 Hydraulic System: Service and Repairs