Adjustments; Adjusting The Traction System For Neutral - Toro Groundmaster Series Service Manual

Adjustments

Adjusting the Traction System for Neutral

Hydraulic System: Adjustments
The traction pedal must return to the N
the forward or reverse position. The machine must not creep in either direction
on level ground when in the traction pedal is in the N
traction system for neutral as follows:
1. Park the machine on a level surface, lower the cutting unit (or attachment)
and set the key switch to the O
Review and follow the
the machine.
2. Raise both front wheels for 2WD machines, or all 4 wheels for 4WD machines
off the floor and support the machine.
3. Loosen the lock nut on the traction (piston) pump adjustment cam.
g301757
1. Traction (piston) pump
2. Lock nut
4. Start the engine and rotate the cam in either direction until the wheels stop
rotating.
position when released from either
EUTRAL
position.
FF
WARNING
Jacking Instructions (page 1–6)
Figure 43
3. Adjustment cam
Page 5–50
position. Adjust the
EUTRAL
before lifting
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A