Toro Groundmaster Series Service Manual page 74

Removing and Installing the Exhaust System (continued)
Engine: Service and Repairs
A hot engine and exhaust system can cause burns.
Allow the exhaust system components to cool before working on or
near them.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the Off position and remove
the key from the key switch.
2. Raise the hood and allow the exhaust system to cool before servicing the
exhaust system components.
3. Remove and install the exhaust system components if necessary.
• Do not reuse exhaust gaskets. Clean any remaining gasket material from
the gasket surfaces and install a new gasket during assembly. Do not use
any type of gasket sealant on exhaust gaskets or gasket surfaces.
• Ensure that all exhaust system connections are free of debris or damage
that may cause an exhaust leak.
CAUTION
Page 4–12 Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A