Testing the Cutting Unit High Trim Height Switch (continued)
Electrical System: Testing the Electrical Components
1
Main
2
Chassis Ground
4. If the harness wires test correctly and the switch LED does not function,
replace the high trim height switch. Connect the high trim height switch to
the machine wire harness and adjust the switch after installation; refer to
Adjusting the Cutting Unit High Trim Height Switch (page
5. Operate the machine and test the high trim height switch operation before
returning the machine to service.
P102
A
Pink
Page 6–36
12 VDC
with key
switch in
the R
UN
position
(do not
start
engine)
6–34).
Groundsmaster
®
3200, 3300 and 3310
19240SL Rev A