Service And Repairs; Wheels - Toro Groundmaster Series Service Manual

Service and Repairs

Wheels

g302853
1. Front wheel and tire – all models
2. Lug nut (as required)
3. Rear wheel and tire – 4WD models
Removing and Installing the Wheels
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
4. Rear wheel and tire – 2WD models
5. Flat washer
6. Washer
1. Park the machine on a level surface, lower the cutting unit (or attachment),
set the key switch to the O
2. Loosen, but do not remove the fasteners (lug nuts or cap screws) that secure
the wheel being removed to the machine.
Before lifting the machine with a jack, review and follow
Instructions (page 1–6).
3. Raise the machine until the wheel to be removed is off the ground. Support
the machine with appropriate jack stands.
4. Remove the fasteners that secure the wheel being removed to the machine,
and remove the wheel.
5. Fit the wheel to the machine and install the fasteners (lug nuts or cap screws)
snugly.
6. Remove the jack stands and lower the machine to the ground.
Figure 111
position and remove the key from the key switch.
FF
IMPORTANT
Page 7–5
7. Cap
8. Cap screw
Jacking
Chassis: Service and Repairs