Toro Groundmaster Series Service Manual page 309

Gearbox
g315870
1. PTO guard
2. Spacer (2 each)
3. Shoulder screw (2 each)
4. Dipstick/breather
5. Copper washer
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
6. Cap screw (4 each)
7. Gearbox bracket – right
8. Gearbox
9. Square key
10. Set screw (2 each)
Removing the Gearbox
Do not start the engine and engage the PTO switch when the PTO
shaft is disconnected from the cutting unit. If you start the engine
and the PTO shaft is allowed to rotate, serious personal injury and
machine damage could result.
If the PTO shaft is disconnected from the cutting unit, disconnect
the PTO electric clutch electrical connector.
Refer to Figure 142 for this procedure.
1. Remove the cutting unit from the machine; refer to the cutting unit Operator's
Manual.
2. Remove the belt covers from the cutting unit.
Figure 142
11.
12.
13.
WARNING
Page 8–17
Pulley
Gearbox bracket – left
Cap screw (4 each)
Cutting Units: Service and Repairs