Toro Groundmaster Series Service Manual page 188

Lift Cylinder
g303516
1. Flange nut (2 each)
2. Flange nut (3 each)
3. Step
4. Pivot pin
Removing the Lift Cylinder
Hydraulic System: Service and Repairs
5. Cap screw
6. Grease fitting
7. Lift cylinder
8. Nylon washer (2 each)
Refer to Figure 70 for this procedure.
1. Remove the front wheel to access the lift cylinder pivot pins; refer to
Removing and Installing the Wheels (page
2. To access the left lift cylinder, remove the step assembly.
3. Support the cutting unit or lift arm.
4. Remove the nut, pivot bolt, and nylon washers securing the barrel end of the
cylinder to the frame.
5. Remove the pivot pin securing the rod end of the cylinder to the lift arm and
lower the cylinder to access the hydraulic fittings.
6. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
7. Clean the fitting and hydraulic hose connections before disconnecting the
hydraulic hoses to prevent system contamination.
8. Disconnect the hydraulic hoses. Cap the fittings and plug the hoses to
prevent system contamination.
Figure 70
10.
11.
12.
Page 5–102
9. Grease fitting
Elbow fitting (2 each)
Lock nut
Pivot bolt
7–5).
General Precautions for
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
5–52).