Toro Groundmaster Series Service Manual page 272

Removing and Installing the Traction Control Components (continued)
g314863
1. Pedal end
Chassis: Service and Repairs
B. Attach the ball joints to the pump lever and the traction pedal hub.
C. Fit the cable housing into the support bracket with a flat washer and a
jam nut on each side of the bracket. Center the cable housing threads on
the bracket and tighten the jam nuts.
D. Clamp the traction cable to the cable bracket below the operator's
platform.
E. Check the traction pedal operation and adjust the traction cable before
returning the machine to service; refer to
(page 7–3).
3. After assembly, make sure that the traction (piston) pump is properly adjusted
for the N position (the machine must not creep in either direction on
EUTRAL
level ground when the traction pedal is in the N
Adjusting the Traction System for Neutral (page
Figure 116
2. Pump end
Page 7–12
Adjusting the Traction Cable
position); refer to
EUTRAL
5–50).
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A