Toro Groundmaster Series Service Manual page 139

After Repairing or Replacing the Components (continued)
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
Fitting) (page 5–7)
O-Ring Fittings) (page
5. After you complete the repairs, check the control linkages or cables for
proper adjustment, binding, or broken parts.
6. Whenever hydraulic fluid has been drained from the pumps (system drain,
flush, or pump removal/installation) it is important to properly prime the
hydraulic pumps, refer to
7. After you disconnect or replace any hydraulic components, operate the
machine functions slowly until the air is out of the system; refer to
the Hydraulic System (page
8. Check for hydraulic-fluid leaks. Shut off the engine and repair leaks if
necessary.
and Installing the Hydraulic Fittings (SAE Straight Thread
5–9).
Priming the Hydraulic Pumps (page
5–62).
Page 5–53
5–60).
Charging
Hydraulic System: Service and Repairs