Rear Axle And Spindles - Toro Groundmaster Series Service Manual

Rear Axle and Spindles

g314919
1. Weight
2. Weight lock
3. Rear bumper
4. Tie rod assembly
5. Cotter pin (2 each)
6. Slotted nut (2 each)
7. Steering stop bolt (2 each)
8. Jam nut (2 each)
Removing the Rear Axle
Chassis: Service and Repairs
9. Rear wheel spindle 2WD
10. Rear wheel spindle 4WD
11. Drag link (2 each)
12. Thrust washer (2 each)
13. Flange bushing (4 each)
14. Retaining ring (2 each)
15. Cap (2 each)
16. Cap screw (2 each)
Refer to Figure 119 for this procedure.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
Figure 119
17.
18.
19.
20.
21.
22.
23.
Page 7–16
Pivot pin
Thrust washer (2 each)
Sleeve bushing (2 each)
Rear axle
Thrust washer
Lock nut
Grease fitting
position and remove
FF
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A