Toro Groundmaster Series Service Manual page 158

Installing the Traction (piston) Pump (continued)
Hydraulic System: Service and Repairs
5. Apply a thin layer of anti-seize lubricant to the traction pump drive shaft and
keyway. Install the key and pump drive pulley. Align the pump pulley with
the engine pulley.
6. Apply medium strength thread locking compound to the pulley set screws
and tighten the set screws from 15 to 16 N·m (135 to 145 in-lb).
7. Fit the pump drive belt over the pulleys and idler.
8. Remove the caps and plugs from the hydraulic fittings and hydraulic lines
then install the hydraulic lines to the piston pump and the gear pump; refer to
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal Fitting) (page
Tighten the gear pump suction hose clamp to 10 N∙m (90 in-lb).
9. Connect the traction cable to the cable bracket and the pump lever; refer to
Traction Pedal, Cable, and Control Assembly (page
10. Connect the neutral switch to the machine wire harness.
11. Install the hydraulic tank; refer to
(page 5–64).
12. Install the front right wheel; refer to
(page 7–5).
13. Prime the hydraulic pump; refer to
14. Charge the hydraulic system; refer to
5–62).
Removing and installing the Hydraulic Tank
Removing and Installing the Wheels
Priming the Hydraulic Pumps (page
Charging the Hydraulic System (page
Page 5–72
7–11).
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
5–7).
5–60).