Toro Groundmaster Series Service Manual page 189

Removing the Lift Cylinder (continued)
Installing the Lift Cylinder
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
9. If the hydraulic fittings are to be removed from the cylinder, mark the fitting
orientation for assembly purposes and remove the fittings from the cylinder.
Discard the O-rings from the fittings.
Refer to Figure 70 for this procedure.
1. If the hydraulic fittings were removed from the cylinder, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
2. Remove the caps and plugs then connect the hydraulic tubes to the cylinder
fittings; refer to Installing Hydraulic Hoses and Tubes (O-Ring Face Seal
Fitting) (page 5–7).
3. Install the pivot pin securing the rod end of the cylinder to the lift arm.
4. Install the nylon washers, pivot bolt, and nut securing the barrel end of the
cylinder to the frame.
5. Lubricate the cylinder pivot grease fittings.
6. Operate the lift cylinder. Check for hydraulic leaks and correct if necessary.
7. Install the step if previously removed.
8. Install the front wheel; refer to
7–5).
9. Check the hydraulic fluid level and adjust if necessary before returning the
machine to service.
Installing the Hydraulic Fittings
Removing and Installing the Wheels (page
Page 5–103
5–9).
Hydraulic System: Service and Repairs