Toro Groundmaster Series Service Manual page 117

Test Procedure – Front Wheel Motor (continued)
g299124
1. Hydraulic pump (P1)
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
2. Remove the hydraulic tube and use 2 hydraulic hoses to install the tester to
the exposed fittings. Make sure the tester is installed in the correct flow
direction (toward the wheel motors) and the tester flow control valve is fully
open.
Note: Remove and reinstall the wheel to access the wheel motor hydraulic
connections if necessary.
3. Clean and disconnect the hydraulic line from the A port of the front wheel
motor that is not being tested.
Figure 31
2. Hydraulic tube
Page 5–31 Hydraulic System: Testing the Hydraulic System