Toro Groundmaster Series Service Manual page 307

Rollers and Skids
g315280
1. Lock nut
2. Roller
3. Spanner
4. Cap screw
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
5. Spacer
6. Spanner
7. Cap screw
8. Carriage screw (2 each)
Removing and Installing the Rollers and Skids
Refer to Figure 140 for this procedure.
1. Park the machine on a level surface, lower the cutting unit, engage the
parking brake, set the key switch to the O
from the key switch.
2. To preserve the roller or skid height, record the mounting hole locations and
remove the rollers or skids from the cutting unit as necessary.
3. Install the rollers or skids in the mounting holes previously recorded. Tighten
the roller fasteners so the screw threads fully engage the nylon insert of the
lock nut while allowing the roller to rotate freely.
Figure 140
10.
FF
Page 8–15
9. Skid/bumper
Flange nut (2 each)
position and remove the key
Cutting Units: Service and Repairs