Toro Groundmaster Series Service Manual page 208

Fuse Identification and Function (continued)
Testing the Fuses
Electrical System: Testing the Electrical Components
g305189
1. Right side frame rail
2. Fuse – RH tail light
3. Fuse – RH brake/turn
Four (5 Amp) fuses are integrated into the optional turn signal/hazard wire
harness. Each fuse is in a separate covered fuse holder. The fuses are located
along the right side frame rail near the exhaust pipe.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
2. Remove the fuse from the fuse block or fuse holder for testing. Check the
fuse, fuse block or fuse holder for damage or corrosion and clean or repair
if necessary.
3. Use a multimeter (ohms setting) and test the fuse for continuity across the
fuse terminals.
4. Replace the fuse if testing determines that it is damaged.
5. If the fuse tests correctly and a circuit problem still exists, check the wire
harness(es); refer to
Figure 83
4. Fuse – LH brake/turn
5. Fuse – LH tail light
Appendix A (page A–1).
Page 6–16
position and remove
FF
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A