Toro Groundmaster Series Service Manual page 269

Replacing the Parking Brake Cables
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
g313966
1. Cotter pin
2. Return spring
3. Clevis pin
4. Washer
5. Brake cable bracket – wheel motor
Refer to Figure 113 for this procedure.
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, and remove the key from the key switch. Ensure that the parking
brake is not engaged.
2. Disengage the parking brake and remove the brake return spring, cotter pin,
clevis pin and washer that attach the brake cable to the brake actuator lever.
3. Loosen the flange nuts that secure the brake cable to the brake cable bracket
near the wheel motor and remove the cable from the bracket.
4. Loosen the flange nuts that secure the brake cable to the bracket below the
brake lever and remove the cable from the bracket.
5. Remove the brake cable ends from the equalizer bracket.
6. Record the location of cable ties and routing of the brake cable for assembly
purposes. Remove the brake cable from the machine.
7. Disassemble any additional brake linkage components as necessary. Repair
or replace the components that are worn or damaged.
Figure 113
6. Brake cable – left
7. Brake cable – right
8. Brake cable bracket – brake lever
9. Jam nut
10. Equalizer bracket
Page 7–9 Chassis: Service and Repairs