Pto Clutch - Toro Groundmaster Series Service Manual

PTO Clutch

g314358
1. PTO clutch
2. Washer
3. Stub shaft
4. Square key
Removing and Installing the PTO Clutch
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
5. Cap screw (2 each)
6. Washer (2 each)
7. Stop strap
8. Spacer (2 each)
For PTO clutch testing and adjustment procedures, refer to
Clutch (page 6–48) and
1. Remove the PTO shaft; refer to
(page 7–19).
2. Record the position of the cable ties securing the wire harness near the clutch
and unplug the clutch harness connector from the machine wire harness.
3. Remove the clutch stop strap. Locate and retrieve the spacers from the
stop strap.
4. Remove the cap screw, spring washers, and the spacer that secure the
clutch to the stub shaft.
5. Slide the clutch from the stub shaft. Locate and retrieve the square key and
the washer from the stub shaft.
6. Apply anti-seize lubricant to the stub shaft and key, then install the washer
and key on the stub shaft.
7. Fit the PTO clutch onto the stub shaft.
Figure 122
10.
11.
12.
Adjusting the PTO Clutch (page
Removing and Installing the PTO Shaft
Page 7–21
9. Lock nut (2 each)
Spacer
Spring washer
Cap screw
Testing the PTO
7–4).
Chassis: Service and Repairs