Toro Groundmaster Series Service Manual page 149

Charging the Hydraulic System (continued)
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
F. Test gear pump (P2) for damage.
9. Turn the steering wheel in both directions so that the steering cylinder moves
in and out several times.
10. Operate the traction pedal in the forward and reverse directions. Make sure
the wheels are turning in the proper direction. If the traction (piston) pump
or a wheel motor was replaced or rebuilt, operate the traction circuit slowly
for 10 minutes.
11. Ensure that the traction pedal returns to the N
and adjust if necessary; refer to
(page 5–50).
12. Lower the machine to the ground.
13. Operate the machine by gradually increasing its work load to full over a 10
minute period.
14. Stop the machine, check the hydraulic components for leaks and tighten
any loose connections.
15. Check and adjust the fluid level in the hydraulic tank if necessary; refer to
the traction unit Operator's Manual.
Note: If new fluid shows any signs of contamination, flush the hydraulic
system again until the fluid is clean; refer to
(page 5–55).
Adjusting the Traction System for Neutral
Page 5–63
position when released.
EUTRAL
Flushing the Hydraulic System
Hydraulic System: Service and Repairs