Toshiba e-STUDIO556 Service Manual page 1326

05/08 Mode Element Sub
element
08 Setting System General
mode
08 Setting System Paper
mode feeding
08 Setting System Network InternetFax
mode
08 Setting System FAX
mode
08 Setting System FAX
mode
e-STUDIO557/657/757/857
Item Subitem Code Sub-
3653
3657
3658
3659
3661
Details Default Acceptable
code value value
Judgment timing for 0
continuous printing
List/report printing 0
from the drawer
specified for "FAX"
To/Bcc Destination 0
Image position and
１
size setting at the
time of forwarding
received fax jobs
Fax operation setting
１
during off-hook
transmission
41
RAM Contents
0-1 SYS Sets the timing for judging whether following job is
printed continuously or not.
0: Consumable life priority (Judging whether the
following job exists or not by printing of last page of
preceding job)
1: Printing performance priority (Judging whether the
following job exists or not by ejection of last page of
preceding job)
* Although continuous printing is performed more
frequently when the value of this code is set to "1", the
life of consumables may be affected. This setting is not
applied to printing with the EFI controller.
0-1 SYS Sets to feed the paper from a drawer whose attribute is
specified to "FAX" when a list or report is printed.
0: Disabled
1: Enabled
0-1 SYS Switches the destination of an internet fax to be sent to
To or Bcc.
0: To
1: Bcc
0-2 SYS This setting is applied only when a received fax job is
forwarded with a pdf format file.
0: Sets to select the paper size from the drawers in
which paper is loaded by corresponding to an image
size. The image position is the upper part of the paper.
1: Sets to select the paper size from the drawers in
which paper is loaded by corresponding to an image
size. The image position is the center part of the paper.
2: Sets to select a standard size paper corresponding
to an image size. The image position is the upper part
of the paper.
- If "FAX" has been set as the attribute of a drawer, its
paper size will be applied when "0" or "1" is selected.
0-2 SYS 0: Transmission is not operable during off-hook
1: Direct transmission is operable during off-hook
2: Transmission is operable during off-hook
Proce Servic
dure e UI
1
1
1
1
1