Toshiba e-STUDIO556 Service Manual page 1222

Sub
05/08 Mode Element
element
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Printer Printer Fine adjustment of
t mode polygonal motor
rotation speed
05 Adjustmen Printer Printer Fine adjustment of
t mode polygonal motor
rotation speed
05 Adjustmen Printer Image Adjustment of laser
t mode writing start position
05 Adjustmen Printer Image Adjustment of laser
t mode writing start position
05 Adjustmen Printer Image Adjustment of drawer
t mode sideways deviation
05 Adjustmen Printer Image Adjustment of drawer
t mode sideways deviation
05 Adjustmen Printer Image Adjustment of drawer
t mode sideways deviation
e-STUDIO557/657/757/857
Item Subitem Code
3237
3350
Adjustment of primary 4000
scanning direction
reproduction ratio
Adjustment of primary 4001
scanning direction
reproduction ratio
Primary scanning 4005
direction
Primary scanning 4006
direction
4018
4018
4018
Sub- Default Acceptable
Details
code value value
Starting time 64 0-255
adjustment of lamp
lighting
Trailing edge 50 0-100
adjustment of
scanning
PPC 128 0-255
PRT 131 0-255
PPC 128 0-255
PRT Refer to 0-255
contents
0 1st drawer 128 0-255
1 2nd drawer 128 0-255
2 3rd drawer 128 0-255
6
RAM Contents
SYS Adjusts the starting time of lamp lighting when the
detection accuracy of dark originals is poor.
Maximum value: 255 (Minimum time + 2040 ms)
Minimum value: 0 (Minimum time)
SYS When the value increases by "1", the trailing edge of
scanned original becomes longer by 0.3 mm at RADF
copying.
When the value decreases by "1", the trailing edge of
scanned original becomes shorter by 0.3 mm at RADF
copying.
* This code is effective when the value of 08-3075 is "1"
(Allowed).
M When the value increases in increments of "1", the
reproduction ratio of the primary scanning direction
increases as follows:
e-STUDIO557/657: 0.3 mm/step
e-STUDIO757/857: 0.1 mm/step
M When the value increases in increments of "1", the
reproduction ratio of the primary scanning direction
increases as follows:
e-STUDIO557/657: 0.3 mm/step
e-STUDIO757/857: 0.1 mm/step
M When the value increases by "1", the writing start
position shifts to the front side by approx. 0.0423 mm.
M When the value increases by "1", the writing start
position shifts to the front side by approx. 0.0423 mm.
<Default value>
e-STUDIO557/657: 113
e-STUDIO757/857: 123
M When the value increases by "1", the image shifts
toward the front side by 0.0423 mm.
M When the value increases by "1", the image shifts
toward the front side by 0.0423 mm.
M When the value increases by "1", the image shifts
toward the front side by 0.0423 mm.
Proce Servic
dure e UI
1
1
1 Yes
1 Yes
1 Yes
1 Yes
4 Yes
4 Yes
4 Yes