Installing The Mgc Card - Avaya CS 1000E Upgrade Procedures

Upgrading a CP PII or CP PIV to CP PM
Procedure 21

Installing the MGC card

The MGC card replaces the existing SSC card. The MG 1010 does not
support the SSC card.
1 Insert the MGC into Slot 0 of the Media Gateway.
Please DESTROY or RETURN the SSC dongle to your local Avaya
Repairs/Returns center upon confirmation of a successful upgrade. If
the SSC system was using remote dongles for any expansion cabinets,
please DESTROY or RETURN to your local Avaya Repairs/Returns
center upon confirmation of a successful upgrade.
Note: If the upgrade fails, you will not be able to revert back to the old
system without the SSC card and dongle.
For the CP PM Call Server, you must use the dongle provided with the
software kit. Chassis Expander dongles may be disposed of, as they are
no longer needed.
2 Connect the serial cable.
• For the MG 1000E, connect the 3-port SDI cable (NTBK48AA) to the
SDI0 port on the Media Gateway. Connect the opposite end of the
cable to a maintenance terminal.
• For the MG 1010, connect a shielded CAT5 Ethernet cable to the
NTC325AAE6 serial cable kit. Connect this cable to the MGU
faceplate port labelled MGC TTY0 in the Media Gateway. Connect
the opposite end of the cable to a maintenance terminal.
Avaya Communication Server 1000E Upgrade
IMPORTANT!
Hardware Upgrade Procedures
Page 155 of 226