Avaya CS 1000E Upgrade Procedures page 76

Page 76 of 226 Upgrading Small System hardware
MG 1010 chassis
NN43041-464 Standard 05.04
* stand-alone Signaling Servers may be one of the following:
• CP PM card
• CP DC card
• Commercial off-the-shelf (COTS) server
Server cards reside in a Media Gateway. COTS servers are separate 1U rack
mount servers.
You must activate the High Speed Pipe package 410 to install any redundancy
options. For more information, see "Appendix A: Upgrading to High
Availability" on page
To proceed with the upgrade, proceed to the "Hardware Upgrade Task
Overview" on page
The Server card interfaces with the Media Gateway through the Gateway
Controller using the ELAN interface, and therefore does not require
backplane connectivity (other than power and slot ID). The following rules
apply to the placement of the Server cards in the Media Gateway 1010:
• When facing the front of the MG 1010, from left to right is MGU slot 21,
Server card slots 22and 23, Gateway Controller slot 0, a metal divider,
and IPE slots 1 to 10.
• The Server cards cannot be placed in slot 0 of any Media Gateway. Slot
0 is reserved for the Gateway Controller.
Note: The CP MG card functions as a Server and a Gateway Controller
while occupying slot 0 in a Media Gateway.
• The MG 1010 provides dedicated slots 22 and 23 for Server cards.
• The MG 1010 supports a 12 Server configuration. A maximum of ten
additional Server cards can be placed in IPE slots 1 through 10. Server
cards in slots 1-10 of a MG 1010 require the NTAK19EC for serial
connections.
December 2011
201.)
81.