Voice Gateway Media Card Installation Summary Sheet - Avaya Nortel Communication Server 1000 Manual

232 Installation and configuration summary
9
10
11

Voice Gateway Media Card installation summary sheet

Nortel recommends that a Voice Gateway Media Card installation summary
sheet (see
sheet" (page
and provisioned. IP address information is usually supplied by the IP
Network Administrator.
To complete the installation summary sheet, the following information is
required:
•
•
•
•
•
Copyright © 2003–2008, Nortel Networks
.
e. Upgrade the software on the Voice Gateway Media Card. See
"Upgrade the Voice Gateway Media Card loadware" (page
f. Reboot the card. See
(page 312).
g. Upgrade the firmware on the card. See
firmware" (page
Configure TM alarm notification feature to receive IP Line SNMP
traps.
Assemble and install an IP Phone. See IP Phones Fundamentals
(NN43001-368).
Configure the IP Phone Installer Passwords (see
Password" (page
a. Enable and set the administrative IP Phone Installer Password.
See Procedure 42 "Configuring the Administrative IP Phone
Installer Password" (page
b. If needed, enable and set a temporary IP Phone Installer
Password. See
Phone Installer Password" (page
Table 70 "Voice Gateway Media Card installation summary
233)) be filled out as the line cards are unpacked, inventoried,
MAC address. This is the ELAN network interface MAC address
on the Voice Gateway Media Card faceplate sticker (for example,
00:60:38:01:12:77).
ELAN network interface IP address, used to perform management
through TM and to communicate with the system
TLAN Node IP address for the IP Telephony node
TLAN network interface IP address on each card
IP address of the active ELNK Ethernet network interface on the system
core
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
"Reboot the Voice Gateway Media Card"
314).
332)).
339).
Procedure 43 "Configuring the temporary IP
342).
—End—
311).
"Upgrade the IP Phone
"IP Phone Installer