Connecting An Ibm Cots Server - Avaya CS 1000E Upgrade Procedures

Note: Refer to Figure 47 or Figure 48 when you preform Procedure 28,
"Connecting an IBM COTS server," on
Procedure 28

Connecting an IBM COTS server

1 Connect the IBM server to the TLAN subnet. Insert the RJ-45 CAT5 (or
better) cable into TLAN Ethernet port on the back of the server. Insert the
other end of the cable into the TLAN subnet of the Layer 2 switch.
2 Connect the IBM server to the ELAN subnet. Insert the RJ-45 CAT5 (or
better) cable into ELAN Ethernet port on the back of the server. Insert the
other end of the cable into the ELAN subnet of the Layer 2 switch.
3 Connect a DTE–DTE null modem serial cable from the serial port on the
back of the server to the serial port on a maintenance terminal. The IBM
x3350 requires a NTRX26NPE6 9 pin female to 9 pin female null modem
cable.
4 Connect the IBM server power cord.
a. Check that the power cord is the type required in the region where
the server is used. Do not modify or use the supplied AC power cord
if it is not the correct type.
b. Attach the female end of the power cord to the mating AC power
receptacle on the server back panel. Plug the male end of the AC
power cord into the AC power source (wall outlet).
5 Configure the baud rate for the serial port on the server to 9 600 b/ps. See
Linux Platform Base and Applications Installation and Commissioning
(NN43001-315).
Note: The IBM X306m Signaling Server ships with the serial port set to
9600 b/ps.
6 Configure the connected maintenance terminal. See Linux Platform Base
and Applications Installation and Commissioning (NN43001-315).
7 Press the Power switch.
Note: Refer to the IBM User Guide for server installation information.
Avaya Communication Server 1000E Upgrade
Installing a Signaling Server
page
End of Procedure
Hardware Upgrade Procedures
Page 187 of 226
187.