Card Cabling - Avaya CS 1000E Upgrade Procedures

Card cabling

Avaya Communication Server 1000E Upgrade
4 Connect a CAT5 or better Ethernet cable to the TTY1 port on the CP MG
faceplate.
5 Connect a NTC325AAE6 serial port adapter (DB-9 or DB-25) to the other
end of the Ethernet cable.
6 Connect the Ethernet cable with adapter to a serial port on the
maintenance terminal.
Note: If you require a longer cable to reach your maintenance terminal,
you can attach a standard serial port cable to the adapter for extended
cable length.
7 Configure the maintenance terminal for VT-100 emulation, 9600 bps,
8,N,1.
8 Connect the ELAN cable:
• Connect one end of a shielded CAT5 or better Ethernet cable to the
1E (ELAN) port on the CP MG faceplate.
• Connect the other end of the Ethernet cable to the ELAN subnet of
the CS 1000E system.
9 Connect the TLAN cable:
• Connect one end of a shielded CAT5 or better Ethernet cable to the
2T (TLAN) port on the CP MG faceplate.
• Connect the other end of the Ethernet cable to the TLAN subnet of
the CS 1000E system.
10 Power on the Media Gateway.
The preceding procedures enable you to upgrade the system one Media
Gateway at a time. For each additional Media Gateway, repeat the necessary
procedures to install a Gateway Controller and Server.
The following sections describe the process required to cable the Gateway
Controller and Server cards.
Upgrading Small System hardware
End of Procedure
Page 97 of 226
Hardware Upgrade Procedures