Avaya CS 1000E Upgrade Procedures page 168

Page 168 of 226
Cabling the CP PM card
NN43041-464 Standard 05.04
Upgrading a CP PII or CP PIV to CP PM
For more information on supported cabling options, see "Appendix C:
Supported cabling options" on
In a MG 1000E or a MG 1010 with CP PM cards in slots 1-10, the SDI port
of the CP PM card routes through the backplane to the 50-pin Amphinol
connector on the back of the MG 1000E. A SDI cable (NTAK19) ships with
the CP PM that adapts the 50-pin Amphinol connector to two 25-pin DB
connectors. Use Port 0 for maintenance access, and Port 1 for an external
modem connection.
In a MG 1010, the MGU provides TTY0 and TTY1 serial ports for the CP PM
card in slot 22 and slot 23. Connect a shielded CAT5 Ethernet cable to the
NTC325AAE6 serial cable kit. Attach this cable to the MGU port labelled
TTY0 for CP1 or CP2. CP1 is for slot 22, CP2 is for slot 23.
Avaya recommends you use direct connections from the faceplate jacks of the
CP PM cards to the Layer 2 ethernet switches. Figure 43 on
illustrates a Media Gateway chassis with a CP PM call processor connected
directly to a Layer 2 switch. Figure 44 on
Gateway chassis with a CP PM Signaling Server connected directly to a
Layer 2 switch.
December 2011
page 211.
page 169
page 169
illustrates a Media