Avaya CS 1000E Upgrade Procedures page 191

4 Connect the Dell server power cord.
a. Check that the power cord is the type required in the region where
the server is used. Do not modify or use the supplied AC power cord
if it is not the correct type.
b. Attach the female end of the power cord to the mating AC power
receptacle on the right-hand side of the server back panel. Plug the
male end of the AC power cord into the AC power source (wall
outlet).
5 Configure the COM1 serial port as the communication port for the
connected maintenance terminal. Set the COM 1 baud rate for the serial
port on the server to 9 600 b/ps. See Linux Platform Base and
Applications Installation and Commissioning (NN43001-315).
6 Configure the connected maintenance terminal. See Linux Platform Base
and Applications Installation and Commissioning (NN43001-315).
7 Press the Power switch.
Maintenance terminal configuration parameters
To configure Signaling Server maintenance terminal configuration
parameters, see the Maintenance chapter of Linux Platform Base and
Applications Installation and Commissioning (NN43001-315).
Avaya Communication Server 1000E Upgrade
Installing a Signaling Server
End of Procedure
Hardware Upgrade Procedures
Page 191 of 226