Network Check - Avaya CS 1000E Upgrade Procedures

Network check

Checking the status of the HSP ports
Avaya Communication Server 1000E Upgrade
Appendix A: Upgrading to High Availability
As the main cabinet has already been built in previous chapters, the steps
required to upgrade to an HA system are:
1 Pick an empty card slot and insert CP PM card into that slot
2 Set the ID of the new call server to core 1
3 Install software (as performed in Avaya Communication Server 1000E
Software Upgrades (NN43041-458))
4 Run LD 137 on the active call server
5 Perform HSP tests and connect the two call servers.
For more information about upgrading to High Availability, see the following
NTPs:
• Avaya Communication Server 1000E Overview (NN43041-110)
• Avaya Communication Server 1000E Planning and Engineering
(NN43041-220)
• Avaya Communication Server 1000E Installation and Commissioning
(NN43041-310)
• Avaya Communication Server 1000E Software Upgrades
(NN43041-458)
Use the LD 137 STAT HSP command to check the status of the HSP. The
following is a sample output of the STAT HSP command.
LD 137
.stat hsp
HSP LINK CARRIER: OK
Auto Negotiation: Enabled
Auto Negotiation Completed: YES
Actual Line Speed: 1000 Mbps
Actual Duplex Mode: Full Duplex
LCS HSP STATE is UP
Page 203 of 226
Hardware Upgrade Procedures