Avaya CS 1000E Upgrade Procedures page 182

Page 182 of 226
NN43041-464 Standard 05.04
Installing a Signaling Server
MGU faceplate labelled TTY0 for CP1 or CP2. CP1 is for the Server
card in slot 22, CP2 is for the Server card in slot 23.
• Connect the other end of the serial cable to the serial port on the
maintenence terminal.
Note: To connect a terminal to the Server card with a NTAK19EC cable,
perform the following steps:
• Connect the NTAK19EC cable to the 50 pin MDF connector on the
back of the desired Media Gateway.
• Connect a 25 pin to 9 pin straight through serial cable to the 25 pin
DB connector at the end of the NTAK19EC cable (a female to female
gender changer may be required). You must povide this adapter.
• Connect the other end of the 25 pin to 9 pin straight through serial
cable to the serial port on the maintenance terminal.
2 Connect the Server card to the ELAN subnet.
• if the Call Server is not connected to the MGC card CE port
— Insert the end of one customer supplied 25-cm RJ-45 CAT5
Ethernet cable into the ELAN network interface port (ELAN port)
on the faceplate of the Signaling Server
— insert the other end of the 25-cm RJ-45 CAT5 Ethernet cable
into the MGC card CE (ELAN) Ethernet port
• if the Call Server is connected to the MGC card CE port
— Insert the end of a longer RJ-45 CAT5 Ethernet cable (not
supplied) into the ELAN network interface port (ELAN port) on
the faceplate of the server
— Insert the other end of the RJ-45 CAT5 Ethernet cable into an
Ethernet port on the ELAN subnet of the Layer 2 switch
3 Connect the Server card to the TLAN subnet.
• if the Call Server is not connected to the MGC card CT port
— Insert the end of one customer supplied 25-cm RJ-45 CAT5
Ethernet cable into the TLAN network interface port (TLAN port)
on the faceplate of the Signaling Server
— Insert the other end of the 25-cm RJ-45 CAT5 Ethernet cable
into the MGC card CT (TLAN) Ethernet port
• if the Call Server is connected to the MGC card CT port
December 2011