Connecting An Hp Cots Server - Avaya CS 1000E Upgrade Procedures

Page 188 of 226

Connecting an HP COTS server

Figure 49
HP DL320-G4 (rear view)
NN43041-464 Standard 05.04
Installing a Signaling Server
In geographic regions that are susceptible to electrical storms, Avaya
recommends that you plug the HP server into an AC surge suppressor.
Figure 49 shows the rear view of the HP DL320-G4 server.
Note: Refer to Figure 49 when you perform Procedure 29, "Connecting
an HP COTS server," on
Procedure 29
Connecting an HP COTS server
1 Connect the HP server to the TLAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the TLAN Ethernet port on the back of the server. Insert
the other end of the cable into the TLAN subnet of the Layer 2 switch.
2 Connect the HP server to the ELAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the ELAN Ethernet port on the back of the server. Insert
the other end of the cable into the ELAN subnet of the Layer 2 switch
3 Connect a DTE–DTE null modem serial cable from the Serial Port on the
back of the server to a maintenance terminal.
4 Connect the HP server power cord.
December 2011
page 188.