Page 154 of 226
Table 19
MGC Serial Port Capabilities
Port
SDI0 (TTY0)
SDI1 (TTY1)
SDI2 (TTY2)
NN43041-464
Standard 05.04
Upgrading a CP PII or CP PIV to CP PM
The 3-port SDI cable is not required for a MGC installation in a MG 1010
chassis. The MG 1010 MGU card provides a the serial connection. Use the
NTC325AAE6 serial cable kit with a MG 1010.
MGC serial port capabilities
Table 19 on
page 154
Modem Support?
Yes (requires null modem to
connect to a TTY)
No (No hardware flow control)
No (No hardware flow control)
December 2011
shows the MGC Serial Port Capabilities.
Used for initial
Configuration?
Yes
No. Port 1 is not enabled
during the initial configuration
of the MGC.
No (Only available after FPGA
is enabled. Not available
during initial configuration
menu display)