Gateway Controller Cabling - Avaya CS 1000E Upgrade Procedures

Gateway Controller cabling

Figure 16
MGC MG Cable
Avaya Communication Server 1000E Upgrade
For the MG 1000E, connect the 3-port SDI cable (NTBK48AA) to the SDI0
port on the Media Gateway. Connect the opposite end of the cable to a
maintenance terminal.
For the MG 1010, connect a shielded CAT5 or better Ethernet cable to the
NTC325AAE6 serial cable kit. Connect this cable to the MGU faceplate port
labelled TTY0 in the Media Gateway. Connect the opposite end of the cable
to a maintenance terminal.
Avaya recommends you use direct connections from the faceplate jacks of the
Gateway Controller to the Layer 2 switch. Figure 16 on
Media Gateway chassis with a MGC connected directly to a Layer 2 switch.
Figure 17 on page 100
connected directly to the Layer 2 switch.
Upgrading Small System hardware
illustrates a Media Gateway cabinet with MGC
Page 99 of 226
page 99 illustrates a
Hardware Upgrade Procedures