Installing The Software - Avaya CS 1000E Upgrade Procedures

Page 192 of 226

Installing the software

Introduction
Before you begin
NN43041-464 Standard 05.04
Installing a Signaling Server
The CP PM and COTS server are out of service during software
installation.
This section provides references you can use when you install CS 1000 Linux
Base and application software a Server.
Servers support no Signaling Server software prior to CS 1000 Release
5.0 and support no SIP Line software prior to CS 1000 Release 6.0.
CS 1000 Release 7.5 Signaling Server and SIP Line software runs only
on the Linux Base platform.
Before installing the software, you must perform the following
• Connect and power up the server. See "Signaling Server connections" on
page 179.
• For CP PM cards, ensure that Switch S5 is in position 2 (to support the
internal hard drive)
• Obtain the CS 1000 Release 7.5 Linux Base installation media.
• For CP PM cards, Avaya advises that you remove the wire on the CF
card clip before you insert a CP PM card into the slot. The clip can fall
open and cause an electrical short.
December 2011
IMPORTANT!
IMPORTANT!