Hardware Upgrade Task Overview; Installing The Cards - Avaya CS 1000E Upgrade Procedures

Hardware Upgrade Task Overview

Installing the cards

Removing the SSC card
Avaya Communication Server 1000E Upgrade
To install the hardware for a Small System upgrade, perform the following
steps:
1 Power down the Main Cabinet or Chassis.
2 Remove the SSC card as described in Procedure 4 on
3 If using an MGC as the Gateway Controller, install the DSP
Daughterboard on the MGC card as described in Procedure 5 on
page 84.
4 Install the Gateway Controller as described in Procedure 6 on
5 Install the Server card as described in Procedure 8 on
6 Cable the cards as shown in "Card cabling" on
7 Power up the Media Gateway.
8 Enter the 'mgcsetup' menu and configure the IP parameters, then reboot
the Gateway Controller.
If the Centralized Software Upgrade (CSU) feature is enabled on the Call
Server, the firmware for the Gateway Controller is downloaded automatically
(or if the internal Compact Flash is blank), otherwise initiate the firmware
download using Overlay 143 commands.
The following sections describe the process required to install the Gateway
Controller and Server cards.
Procedure 4
Removing the SSC Card
1 Power down the system.
2 Unlatch the SSC card.
Upgrading Small System hardware Page 81 of 226
page 81.
page 94.
page 97.
Hardware Upgrade Procedures
page 87.