Connecting A Terminal - Avaya CS 1000E Upgrade Procedures

• Verify the new key code using the DKA program.
• Print site data.

Connecting a terminal

Procedure 16
Connecting a terminal
A maintenance terminal is required to access the Call Servers during the
upgrade procedure.
1 Connect a terminal to the COM 1 port on the faceplate of the CP PII or
CP PIV card of the inactive Call Server.
2 The settings for the terminal are:
a. Terminal type: VT100
b. 9600 Baud
c. Data bits: 7
d. Parity: odd
e. Stop bits: 1
f. Flow control: none
Note: If the telnet session is set to 7 odd 1 versus 8 none 1,the system
messages generate before the INI prints, otherwise a portion of the
database conversion reference of lost TN's does not appear.
Printing site data
Print site data to preserve a record of the system configuration (Table 17 on
page 134). Verify that all information is correct. Make corrections as
necessary.
Avaya Communication Server 1000E Upgrade
Upgrading a CP PII or CP PIV to CP PM
End of Procedure
Page 133 of 226
Hardware Upgrade Procedures