Configuring The Mgc On The Call Server - Avaya CS 1000E Upgrade Procedures

Configuring the MGC
Use Procedure 22 to configure the MGC through CLI.
Procedure 22

Configuring the MGC on the Call Server

Initial configuration of the MGC is command line ONLY.
The MGC is shipped with "gold" software in onboard flash memory. If
centralized software upgrade is enabled on the Call Server, the MGC is
upgraded automatically (or it can be upgraded manually through LD 143).
There are two ways to enter mgcsetup:
• If no IP information exists on the MGC, it will boot directly into the setup
menu.
• If IP information exists, use <CTRL>L<CTRL>D<CTRL>B, (provide
LDB username and password to access LDB). Invoke the mgcsetup
command.
The MGC Shells can be accessed using the following commands:
• <CTRL> OAM, (provide OAM username and password to access
OAM shell)
• <CTRL> LDB, (provide LDB username and password to access
LDB)
1 If IP information already exists on the MGC card, input the CLI command
mgcsetup.
2 Enter network IP information at the MGC setup menu:
ELAN IP : 192.168.3.33
ELAN subnet mask : 255.255.255.0
ELAN gateway IP : 192.168.3.1
Primary CS IP : 192.168.3.32
Note: Depending on the date of manufacture, the Gold image may
prompt for TLAN and/or secondary call server information. If these
prompts appear they can be ignored. This information is configured
through EM and is retrieved by the MGC at registration. The new image
after upgrade will not have these prompts.
Avaya Communication Server 1000E Upgrade
Upgrading a CP PII or CP PIV to CP PM Page 157 of 226
Hardware Upgrade Procedures