Server Card Hardware Installation - Avaya CS 1000E Upgrade Procedures

Server card hardware installation

Installation in an Avaya Communication Server 1000E system
Avaya Communication Server 1000E Upgrade
This section contains general instructions to install the Server card in a Media
Gateway. For additional software installation instructions, see Linux Platform
Base and Applications Installation and Commissioning (NN43001-315).
CP PM circuit cards contain several switches. All switch settings must be
factory defaults except for the switch labelled S5. Switch S5 must be in
position 2 to support the internal hard drive on the CP PM card when
you deploy a CP PM Signaling Server or a CP PM Co-resident Call
Server and Signaling Server.
The original CP PM card introduced in Release 5.0 can be used as a Signaling
Server, however upgrades to the hardware and software are required. The
CP PM card must meet
CP PM BIOS version 18 or higher
Linux upgrade kit. For more information, see Linux Platform Base and
Applications Installation and Commissioning (NN43001-315).
Note: The CP PM version 2 card (NTDW99CAE6) does not require a
BIOS upgrade or upgrade kit to support Linux.
Ensure that the Dip Switch (S5) is set to position position 2 if using the
CP PM card as a Signaling Server.
Server cards cannot use slot 4 on the older Option 11C Mini Chassis (slot 4
is allocated for the 48 port DLC only on older chassis).
MG 1010 slots 22 and 23 require the NTDW53 CP DC card, or NTDW99
CP PM card with metal faceplate. MG 1000E and MG 1010 slots 1-10
support NTDW53 CP DC cards, NTDW61 CP PM cards, and NTDW99
CP PM cards.
If you require more than two Server cards in a MG 1010, you
can install additional Server cards in slots 1-10.
The CP MG card occupies slot 0 in a Media Gateway.
Installing a Signaling Server
IMPORTANT!
all required specifications (2GB ram, 40GB hard drive,
). You can upgrade a CP PM card with the
Page 177 of 226
Hardware Upgrade Procedures