Connecting A Dell Cots Server - Avaya CS 1000E Upgrade Procedures

Page 190 of 226

Connecting a Dell COTS server

Figure 50
Dell R300 server (rear view)
NN43041-464 Standard 05.04
Installing a Signaling Server
In geographic regions that are susceptible to electrical storms, Avaya
recommends that you plug the Dell server into an AC surge suppressor.
Figure 50 shows the rear view of the Dell R300 server.
Note: Refer to Figure 50 when you perform Procedure 30, "Connecting
a Dell COTS server," on
Procedure 30
Connecting a Dell COTS server
1 Connect the Dell server to the TLAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the TLAN Ethernet port on the back of the server. Insert
the other end of the cable into the TLAN subnet of the Layer 2 switch.
2 Connect the Dell server to the ELAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the ELAN Ethernet port on the back of the server. Insert
the other end of the cable into the ELAN subnet of the Layer 2 switch.
3 Connect a DTE–DTE null modem serial cable from the Serial Port on the
back of the server to a maintenance terminal.
December 2011
page 190.