Avaya CS 1000E Upgrade Procedures page 95

5 Connect the serial cable.
• For a MG 1000E or MG 1010 with Server cards in slots 1-10, connect
the 2-port SDI cable. The 50-pin Amphenol NTAK19EC connects to
the back of the Media Gateway.
• For a MG 1010, connect a shielded CAT5 or better Ethernet cable to
the NTC325AAE6 serial port adapter. Connect this cable to the MGU
faceplate port labelled TTY0 for CP1 or CP2. CP1 is for slot 22, CP2
is for slot 23.
• Connect the opposite end of the serial cable with adapter to the serial
port on the maintenence terminal.
Note: To connect a terminal to the Server card with a NTAK19EC cable,
complete the following steps:
• Connect the NTAK19EC cable to the 50 pin MDF connector on the
back of the desired Media Gateway.
• Connect a 25 pin to 9 pin straight through serial cable to the 25 pin
DB connector at the end of the NTAK19EC cable (a female to female
gender changer may be required). You must povide this adapter.
• Connect the other end of the 25 pin to 9 pin straight through serial
cable to the serial port on the maintenance terminal.
Avaya Communication Server 1000E Upgrade
Upgrading Small System hardware
End of Procedure
Page 95 of 226
Hardware Upgrade Procedures