Table of Contents
Advertisement
Replacing air filters
To ensure your server cools and functions properly, remove and clean air filters every six
months in clean environments and every three months in industrial or dirty environments. If
they appear to be damaged or become inefficient, replace the filters. There are four air filters
on the 1002rp server—one inside each of the two doors of the front bezel, and two on the top
half of the front bezel. They are made of polyester foam material and are flame retardant.
Requirements
You require the customer's chassis keys for the front bezel.
To replace the front bezel air filter
1. Remove the front bezel from the chassis. See
2. Pull the filters away from the Velcro strips that secure them to the bezel.
3. Replace the filter by seating the new filter pads evenly over the Velcro strips and
4. Install and lock the front bezel on the chassis.
To replace the door air filter
1. Unlock and open the front doors.
2. The air filter is trapped between the inside of the door and the wire. The wire pivots
3. Remove and replace the air filter.
4. Pivot the wire to trap the filter, ensuring that the ends of the wires are pinched inside
5. Close and lock the doors.
Replacing the power supply
The power supply is hot-swappable. This means that you can replace the power supply without
powering down the server.
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
76.
securing them.
near the key lock. Pull the wire away from the key lock to free the air filter.
the door.
Replacing air filters
To remove the front bezel
December 2010
on page
79
Advertisement
Table of Contents
