Arp Command Parameters; The Nbtstat Command - Avaya CallPilot 1002rp Maintenance And Diagnostics

Using Windows online diagnostic tools

ARP command parameters

Table 6: ARP command parameters
Parameter
-a
-g
inet_addr
if_addr
eth_addr
-N if_addr
-d
-s
To run the arp command from Windows
1. Click Start → Programs → Accessories → Command Prompt.
2. At the Command prompt, type arp with the required parameters (for example, arp
3. Press Enter.
4. Type Exit to exit the Command Prompt window and return to Windows.

The nbtstat command

The nbtstat command displays protocol statistics and current TCP/IP connections using NBT.
34 Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Displays current arp entries by interrogating the current protocol data. If
inet_addr is specified, the IP and physical addresses for only the
specified computer appear. If more than one network interface uses arp,
entries for each arp table appear.
Same as -a.
Specifies an Internet address.
Specifies the Internet address of the interface where the address
translation table should be modified. If not present, the first applicable
interface is used.
Specifies a physical address.
Displays the arp entries for the network interface specified by if_addr.
Deletes the host specified by inet_addr.
Adds the host and associates the Internet address inet_addr with the
physical address eth_addr. The physical address is given as six
hexadecimal bytes separated by hyphens. The entry is permanent.
Result: The Command Prompt window appears.
-g 200.286.0.32).
Result: The system runs the arp command.
Description
December 2010