Table of Contents
Advertisement
Replacing the fuse (AC system only)
The fuse is located below the power input socket on the rear panel. When the server fuse
blows, the server stops operating.
Caution:
Risk of equipment damage and personal injury
Disconnect power from the server before replacing a fuse.
Requirements
You require the following:
• an approved fuse for replacement
Two different types of fuses exist: one for North America, and one for international use.
Ensure that the fuse you are replacing has been approved by Avaya for your region.
• a flat-blade screwdriver
To replace the fuse
1. Power off the server.
2. Unplug the power cable from the wall outlet.
3. Unplug the power cable from the power input socket on the server.
4. Unscrew the fuse receptacle (see A in
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Replacing the fuse (AC system only)
Figure 18: Fuse receptacle
on page 90).
December 2010
89
Advertisement
Table of Contents
