Avaya CallPilot 1002rp Maintenance And Diagnostics page 123

5. Plug the Intel D/480JCT-2T1 PCI card 1 in PCI slot 5.
6. Connect the 3 drop CT-Bus cable so all three connectors are securely connected
To configure three MPB96 and four T1 PCI cards
1. Plug the MPB96 card in PCI slot 3.
2. On the first Intel D/480JCT-2T1 PCI card:
3. Plug the Intel D/480JCT-2T1 PCI card 1 in PCI slot 4.
4. On the second Intel D/480JCT-2T1 PCI card:
5. Plug the Intel D/480JCT-2T1 PCI card 2 in PCI slot 5.
6. Plug the MPB96 card in PCI slot 6.
7. On the third Intel D/480JCT-2T1 PCI card:
8. Plug the Intel D/480JCT-2T1 PCI card 3 in PCI slot 7.
9. On the fourth Intel D/480JCT-2T1 PCI card:
10. Plug the Intel D/480JCT-2T1 PCI card 4 in PCI slot 8.
11. Plug the MPB96 card in PCI slot 9.
12. Connect the 7 drop CT Bus cable to all MPB96 and T1 cards. Ensure that the end
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
b. Install a termination jumper on P700 3&4 termination jumpers ON (to
enable CT Bus termination).
Note:
Only one Intel D/480JCT-2T1 PCI card in the system (the last on the CT Bus
cable) should have the termination jumper set to ON.
to all cards.
Note:
If a 7 drop cable is used in this configuration, ensure that the end connectors are
connected to the end cards and no connector is left dangling at any end of the
cable.
a. Set the card SW100 ID rotary dial switch to 0.
b. Ensure that there are no termination jumpers installed on P700.
a. Set the card SW100 ID rotary dial switch to 1.
b. Ensure that there are no termination jumpers installed on P700.
a. Set the card SW100 ID rotary dial switch to 2.
b. Ensure that there are no termination jumpers installed on P700.
a. Set the card SW100 ID rotary dial switch to 3.
b. Ensure that there are no termination jumpers on P700 pins 3 and 4.
connectors are connected to the end cards and no connector is left dangling at any
end of the cable.
T1 switch connectivity
December 2010 123