Agilent Technologies 1290 Infinity User Manual page 84

3
LC Injector HTC/HTS Description and Installation
Installation
Installing a Trayholder
1 If a Tray Holder was shipped with the LC Injector HTC/HTS, loosen the two
2 Install the Tray Holder with the mounting clamp teeth fitting into the
3 Be sure that the clamps fit completely into the grooves. Alternately tighten
4 Double check whether the two Tray Holder clamps are correctly attached to
84
Torx screws on the two mounting clamps located on top of the Tray Holder
legs.
Figure 35 Installing a Tray Holder
grooves on the bottom of the X-axis.
the two Torx screws until the two mounting clamps are firmly in place.
the X-axis (see Figure 10 on page 54).
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual