Agilent Technologies 1290 Infinity User Manual page 83

Installing a Microplate Stack
1 If a Stack (a Tray Holder with multiple drawers) was shipped with the LC
Installation of Stack and Tray Cooler is described in detail in the Addendum to the User
N O T E
Manual MT/DW Tray, Stack, and Cooler Upgrades for Agilent LC Injectors HTC/HTS.
2 Carefully lift the X-axis assembly on top of the Stack with the mounting
3 Be sure that the clamps fit completely into the grooves. Alternately tighten
4 Double check whether the Stack clamps are correctly attached to the X-axis
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual
Injector HTC/HTS, loosen the two Torx screws on the two mounting clamps
located on top of the Stack. The example below shows the two stack models
with 3 and 6 drawers.
Figure 34 Installing a Microplate Stack with 3 or 6 Drawers
clamp teeth fitting into the grooves on the bottom of the X-axis.
the two Torx screws until the two mounting clamps are firmly in place.
(see Figure 10 on page 54).
LC Injector HTC/HTS Description and Installation
3
Installation
83