Agilent Technologies 1290 Infinity User Manual page 145

Item
Ndl Cln Path
Waste to
Clean Volume
Clean Count
Max Fill Spd
Max Eject Spd
Rinse Time
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual
LC Injector HTC/HTS Description and Installation
Description
A Path can be assigned to the Wash Station.
The Waste position is assigned to the Wash Station.
A percentage of the syringe maximum volume is defined for the cleaning
step.
The counter monitors the number of wash cycles. The setting in the
method has the same functionality and the value is mirrored to the
Extended User Level.
The fill speed for the syringe is defined with this item. If the maximum value
of the Fill Speed (10.0 mL/s) is selected, the system takes the injection
syringe Fill Speed as defined in the method.
The Eject Speed is the speed used to eject the wash solvent during the
wash cycle. This speed is usually higher than the Fill Speed. If the
maximum value of the Eject Speed (10.0 mL/s) is selected, the system
takes the injection syringe Eject Speed as defined in the object class
Syringe.
Rinse is the time to rinse the wash port with wash solvent after the wash
cycle of the syringe has been finished.
In the case of a Fast/Active Wash Station, the syringe needle is pulled out
of the wash port. The wash solvent flows without restriction. As a result,
higher solvent consumption has to be taken into consideration.
3
Special Functions
145