Agilent Technologies 1290 Infinity User Manual page 133

Section F3-Setup / Objects
The same as is described above applies for the section Objects opened in
Extended User Mode. New classes are visualized and known classes may
contain new items accessible only on the level of the Extended User Mode.
To open this level, use the following path:
Figure 67
Object
Syringes
Vials
Tray Types
Tray Holders
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual
LC Injector HTC/HTS Description and Installation
Selecting Objects in Extended User Mode
Description
At this level all loaded syringes are selectable. At the Utilities user level
only the active syringe is visible.
The Firmware Objects accessed on the Extended User Mode have more
specific items selectable than at the User level. Tolerances or ranges such
as, e.g. Maximum Penetration can be defined and limited for the user such
that this value cannot be exceeded. In the Object Tray Types, details for the
various Items are described more closely.
The object class Tray Type is only accessible via the Extended User Level.
All loaded Tray Types are visible and selectable. Details, see
page 137.
The Firmware Objects accessed on the Extended User Level have more
specific items selectable than at the User level. Depending on the type of
Tray Holder, e.g. an Access and Restore Path or a Heater and Agitator
(motor) is assigned. Typical example, the Tray Holder Agitator.
3
Special Functions
"Tray Type" on
133