Trays
The following object Tray Items can be changed by selecting the particular item.
First select the desired Tray, such as Tray1.
Item
Tray Holder
TrayTypeGroup
Tray Type
Offset X
Offset Y
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual
LC Injector HTC/HTS Description and Installation
Description
The Tray Holder to which the Tray is assigned is specified.
All Tray Type Groups which are allowed for this particular combination of
Tray and Tray Holder are displayed. The TrayTypeGroup for the Tray Type
itself is specified for each Tray Type.
The Tray Type to be used is linked to the Tray.
This item is usually set at User Level in Utilities > Trays. See above.
The X offset is defined as the distance from the center of the teaching
position from the Tray Holder to the edge of the Tray in X-direction.
Measured in mm.
This item is available at User Level in section Utilities > Tray and can be
used for fine tuning a Tray installed in a Tray Holder. Important for
well-plates 384 installed in a Stack.
N O T E
Position#1 is the only correction point.
The Y offset is defined as the distance from the center of the teaching
position from the Tray Holder to the edge of the Tray in Y-direction.
Measured in mm.
This item is available at User Level in section Utilities/Tray and can be used
for fine tuning a Tray installed in a Tray Holder. Important for well-plates 384
installed in a Stack.
N O T E
Position#1 is the only correction point.
3
Special Functions
141