Agilent Technologies 1290 Infinity User Manual page 59

Installing the Keypad Terminal and Safety Shield
Figure 15
1 Install the safety shield on the left and right sides to the outside of the X-
2 Install the Keypad mounting bracket on either the right or left side of the
3 Connect one end of the white coiled cable (Part No. SS8J-700) to the Keypad
4 Place the Keypad terminal onto its mounting bracket.
Installing the Power Supply
1 Locate the power supply, the DC power cable, and the AC power cable.
2 Set the power supply switch to the OFF position.
3 Connect one end of the DC power cable to the power supply and the other
4 Connect the female end of the AC power cable to the power supply. Then
Agilent 1290 Infinity LC Injectors HTC/HTS User Manual
Installing Keypad Terminal
axis. Use the provided, longer thumbscrew on the side where you plan to
install the keypad.
X-axis.
and the other end to the TERMINAL (SER3) interface jack on the rear side
of the X-axis. For details see
end to the POWER connector at the rear side of the X-axis.
connect the male end to an AC power outlet.
LC Injector HTC/HTS Description and Installation
Figure 36 on page 85 or
Installation
Figure 37 on page 86.
3
59